Theta Magnetic Sweeper

Recommended Industry Applications

The Theta is a light, easy to use continuous discharge magnetic sweeper.

Pick up shot of all sizes faster!

Theta Continuous Discharge Shot blasting Magnetic Sweeper is specifically designed for heavy use by shot blasters who need to pick up steel shot of all sizes.

 

The Theta is light and easy to use so you can get the job done faster. This sweeper is so easy to use that it turns an undesirable job into one that no one minds doing. It’s like using a power circular saw versus a handsaw.

 

The Theta is much lighter than most conventional sweepers because it uses rare earth magnets. It is only 21 pounds, making for less tiring work.

 

The Theta makes it easy to pick up, clean off and dispose of debris. It uses Bluestreak’s patented Ripwhirl Technology to continuously clean shot off its magnetic drum and deposit the shot into an on board removable debris tray as you push the sweeper.

 

Productivity is greatly increased due to the elimination of the clean off and the pickup efforts associated with conventional magnets.

 

The Theta reduces clean up times by 40% making it almost twice as fast as traditional magnetic sweepers.

$1,399.99 USD

See Pricing For All Models Below

Theta

Product Pricing

 Theta 25

Theta 25

$ 1399.99

Shipping

Weight: 24.2 lbs | Length: 37
Width: 9 | Height: 9

SKU:

TH25


* If you want to order more than one you may add or adjust product quantities once you have added the product to your shopping cart.

Specs

Theta Series Theta 25
SKU TH25
Sweeper Width 25″
Ground Clearance 0.150 inches at lowest fin point
Cleaning Method Automatic Continuous Discharge
Lifting Weight (using 2.5″, 8 penny nails) N/A
Height Adjustability None
Housing Construction High Impact PVC
Wheels Front 5″ and rear 3″ Thermoplastic rubber, non-marking with sealed precision bearings, and rugged polypropylene hubs, 5″ wheels each have a 300 lb load rating.
Magnetic Surface Area N/A
Maximum Lifting Height 1″ for 100% shot pickup.
Total Sweeper Weight 21 lbs
Total Shipping Weight 24 lbs
Shipping Dimensions 37″L x 9″W x 9″H
Maintenance None
Accessories None
Pricing Range $1399.99

CAD Drawings

There are no CAD drawings.

Reviews

4.3
Based on 3 reviews
5 star
33
33%
4 star
67
67%
3 star
0%
2 star
0%
1 star
0%
1-3 of 3 reviews
  1. We have two of these, they’re useful.

  2. Works well, designed and made well; comes disassembled, went together in 30min with good instructions. Only downside/liability is the plastic cylinder critical to operation (mine came cracked 2″ on the edge, likely from a bump in shipping). The essence of the tool is this ribbed cylinder which is also the only non-metal part (except wheels and plastic rod sheaths under the removable tray. Cylinder could be damaged by something falling on it or an employee smacking it into an exposed bolt in the floor. Very expensive but saves from having to drop & pick up piles of steel shot. If it lasts forever it’ll be worth it as a necessary business tool; if I have to replace the cylinder I’ll wish I’d bought the all-metal BORA model.

  3. The magnet has done a great job. Picks up shot, floor sweepings and dust and parts that have fallen on the floor that are scrap.

Literature


Theta Series Brochure PDF

1 file(s) | 263.50 KB


Theta Assembly Instructions PDF

1 file(s) | 532.60 KB

Parts

 

Part #2 Theta aluminum upper Y handle and grip (Item i) (1 pc)

$ 48.67
 

Part #1 Theta bolt bag of assorted steel hardware (Items a b c d e f g h) (46 pcs)

$ 25.37
 

Part #10 Theta 5″ Thermoplastic Rubber Wheels mounted on a Polypropylene Core(Item r) (2 pcs)

$ 54.52
 

Part #3 Theta aluminum lower Y handle arms (Item j) (2 pcs)

$ 76.97

Accessories

There are no Theta accessories.

Continuous Discharge for 100% Pickup Strength!

Theta Continuous Discharge Shot blasting Magnetic Sweeper always has full pick up strength because the shot is continuously removed from the magnet. Using Ripwhirl Technology the shot is continuously cleaned off the magnetic drum and deposited into an on board removable debris tray as you push the sweeper.

Works great.

theta-continuous-discharge-shot-blasting-magnet-bluestreak-equipment-demo-closeup

Super strong but light shot blasting sweeper magnet.

The Theta Continuous Discharge Shot blasting Magnetic Sweeper is a super strong but light magnet. It is the lightest continuous discharge sweeper of Bluestreak Equipment's continuous discharge models.

 

It is much lighter then most conventional sweepers at only 21 lbs. It is lighter weight because it uses super strong rare earth magnets for lifting power. Because the magnets are very strong there is no need for a huge, heavy magnet assembly. This lighter weight makes for less tiring work for anyone pushing the sweeper.

 

The super strong N42 rare earth magnets also have exceptional pickup power allowing the Theta to pick up 100% of steel shot out of cracks 1” deep. This allows you to thoroughly clean cracks and expansion joints which results in less shot showing up in the finished floor coating which has a direct effect on the quality of the finished floor. It can pick up shot from deeper cracks but gets a smaller percentage of it as the depth increases.

 

The Theta features Bluestreak’s patented Ripwhirl Technology to continuously clean shot off the magnetic drum as the drum rotates. The shot is automatically deposited into an on board removable debris tray as you push the sweeper.

 

The debris tray holds approximately 22 lbs of steel shot. Because the drum continuously cleans off the magnet, you always have full pickup strength increasing the effectiveness of shot pickup. This eliminates going over the same area multiple times to get all the shot.

 

Productivity is also greatly increased due to the elimination of the clean off and pickup efforts associated with conventional magnets allowing a 40% reduction in clean up time over conventional magnetic sweepers making it almost twice as fast.

On Board Debris Tray

Easily remove the on board debris tray and get rid of the shot that has been collected. It’s easy to see when the tray is full and when it’s full the handle is easy to grab and you just dump it into whatever you want.  The debris tray holds approximately 22 lbs of steel shot.

Comfort Grip Handle

theta-continuous-discharge-shot-blasting-magnet-bluestreak-equipment-side-view

Sealed Precision Bearing Wheels

The bearings in the wheels are sealed precision bearings. If you get shot or dust near the wheel area there is no way anything will get inside and nothing will get damaged. The wheels are made of soft non-marking Thermoplastic grey rubber so they won't leave any marks on floor surfaces.

Super Strong Rare Earth Magnets

The Theta uses N42 rare earth magnets that won’t lose their strength over time and are permanently charged. Because of the rare earth magnet power, the Theta picks up 100% of steel shot from 1″ below the wheels. This means it can pick up 100% of steel shot out of cracks 1″ deep. It can pick up shot from deeper cracks but gets a smaller percentage of it as the depth increases. This allows you to thoroughly clean cracks and expansion joints which results in less shot showing up in the finished floor coating which has a direct effect on the quality of the finished floor.

Picks up Even Fine Metal Debris

A customer recently sent us a bag of fine metal shaving debris from a shot blasting site. He wondered how the Theta would perform picking up this very fine dust. We get asked this question a lot so we decided to put the Theta to the test in this video.

Play Video
theta magnet shot blasting magnet bluestreak equipment

Built to Last!

Theta Shotblasting Magnetic Sweeper is designed and built to last with an aluminum welded construction and high impact PVC magnetic housing.  Because of the quality of its design and construction and the availability of replacement parts when needed you can keep your Theta going for years resulting in lower long term costs of ownership compared to many cheaper magnetic sweepers.

Pick Up Shot from Against Walls and Edges

The Edger accessory further increases the pickup power and efficiency of continuous discharge magnetic sweepers. This accessory uses a spinning finned disc with internal rare earth magnets to pull shot up and away from walls or edges and throws the shot in front of the main sweeping drum  so it can be picked up and deposited into the onboard bin. The Edger works with the Fusion and Theta models and simply bolts onto the side of the sweeper, it can be folded up and out of the way for easy transport and eliminates the need for sweeping shot away from walls or edges when cleaning up after shot blasting.  Theta and Fusion models purchased before February 1st 2024 can be retrofitted with the edger attachment using part # 8 available on the parts page.

Looking up through glass floor to see how Edger works

Additional Features

Shipping Costs & Methods

Shipping Options

Shipping options and charges available at checkout.

Real-Time Shipping Rates

Shipping rates are calculated by connecting directly to shipping carriers, giving you real time shipping quotes when you order online.

International Shipping

Some international orders outside North America may require a freight quote on checkout before the order can be completed.

Payment Methods

Full line of magnetic sweeper products. All items in stock. Shop Online and Pay by Visa, Visa Debit, Mastercard, American Express, Discover, Diners Club, JCB, PayPal or Pay by Cheque or EFT / Wire Transfer.

 

card-visacard-mastercard card-amex card-discover card-dinersclub card-jcb Debit Visa
PayPal

Made In Canada

All products proudly designed and manufactured in Canada
(since 2005).

No Border Issues

We handle U.S. customs clearance so you don’t have to.
Pay only the charges identified at checkout.

All Items In Stock

All products are stocked for quick shipping and delivery.