Continuous Discharge Magnetic Sweeper for surface preparation operations


Specifications for Theta Series
Equipment Type: Push style magnetic sweeper in one 25 inch width.
Sweeping Width:	Theta25 - 24"
Ground Clearance:	0.150 inches at lowest fin point
Price in US$:	Theta25 - $1499.99
Cleaning method	Automatic Continuous Discharge
Lifting Weight using 2 1/2", 8 penny nails:	N/A
Height Adjustability:	None
Housing Construction:	High impact PVC
Wheels:	Front 5" and rear 3" Thermoplastic rubber, non-marking with sealed precision bearings.
Magnetic Surface Area:	N/A
Maximum Lifting Height (2.5", 8 penny nails):	1" for 100% shot pickup.
Total Sweeper Weight:	Theta25 - 21 lbs
Maintenance:	None

A Continuous Discharge Magnetic Sweeper For Shotblasting Surface Preparation Operations

Series Overview

Specifically designed for heavy use by shotblasters who need to pick up steel shot of all sizes from S170 to S550.

The Theta uses Bluestreak's patented Ripwhirl Technology to continuously clean shot off its' magnetic drum and deposit the shot into an onboard removable debris tray as you push the sweeper. The tray holds approximately 22lbs of steel shot. Because the drum continously cleans off the magnet, you always have full pickup strenth increasing the effectiveness of shot pickup.

The unit is much lighter then most conventiuonal sweepers at only 21lbs making for less tiring work. Productivity is greatly increased due to the elimination of the clean off and pickup efforts associated with conventional magnets.

Automatic Continuous Discharge Magnetic Sweeper!

Automatic Continuous Discharge System continuously cleans shot off its' magnetic drum and deposits shot into an onboard removable debris tray as you push the sweeper. The Theta tray holds approximately 22lbs of steel shot.
Increases Effectiveness: The Theta picks up 100% of steel shot from 1" below the wheels, that means it can pick up 100% of steel shot out of cracks 1" deep. it can pick up shot from deeper cracks but gets a smaller percentage of it as the depth increases. This allows you to thoroughly clean creacks and expansion joints which results in less shot showing up in the finished floor coating which has a direct effect on the quality of the finished floor.
Increase Productivity: Quickly recover steel shot of all sizes. The Theta cleans up the same size of area 40% faster than a traditional magnetic sweeper.
Increased Ease of Use: There is a real improvement experienced by the operator of the Theta because there is not as much bending over involved. The tray holds 22 lbs of shot, it's easy to see when the tray is full and when it's full the handle is easy to grab and you just dump it into whatever you want. The sweepers are so easy to use that it's turns an undesirable job into one that no one minds doing. It's like using a power circular saw versus a handsaw.
Reduced Long Term Cost: The Theta is designed to last. And because of the quality of its design and construction and because of the availablity of replacement parts when needed you can keep your Theta going for years resulting in lower long term costs of ownership compared to many cheaper magnetic sweepers. Parts are available for the Theta on this website or from Bluestreak dealers.
Increase Your company's adaptability / flexibility to economic cycles: When you're really busy the Theta allows you to get the job done faster with the same amount of staff without hiring and when things slow down you won't have too many staff.
Long maintenance free life. N42 rare earth magnets won't lose their strength over time and are permanently charged.
Non-marking Thermoplastic rubber wheels with sealed bearing won't leave markes on floor surfaces and no dust or grit can get into the bearings.