Atmos Series™

A Continuous Discharge Magnetic Sweeper For Shotblasting Surface Preparation Operations

Series Overview

Specifically designed for heavy use on large areas by shotblasters who need to pick up steel shot of all sizes from S170 to S550.

The Atmos uses Bluestreak's patented Ripwhirl Technology to continuously clean shot off its magnetic drum and deposit the shot into an onboard removable debris tray as you push the sweeper.

Each of the 2 trays hold approximately 42lbs of steel shot. Because the drum continously cleans off the magnet, you always have full pickup strength increasing the effectiveness of shot pickup.

Productivity is greatly increased due to the elimination of the clean off and pickup efforts associated with conventional magnets.

Purchase 2 additional trays as an accessory to make a total of 4 trays to extend your sweeping time before having to empty the trays.

• Automatic Continuous Discharge System continuously cleans shot off the magnetic drum and deposits shot into an onboard removable debris tray as you push the sweeper.
• Each of the 2 trays hold approximately 42lbs of steel shot allowing you to go further before emptying the tray.
• Increases Effectiveness: The Atmos picks up 100% of steel shot from 1 3/4" below the wheels, that means it can pick 100% of steel shot from out of cracks 1 3/4" deep. It can pick up shot from deeper cracks but gets less and less of it as the depth increases. This allows you to thoroughly clean out cracks and expansion joints which results in less shot showing up in the finished floor coating which has a direct effect on the quality of the finished floor.
• Increase Productivity: Quickly recover steel shot of all sizes. The Atmos cleans up the same size of area faster than a traditional magnetic sweeper. Real world comparisons show that the Atmos is 80% faster at cleaning up shot than a traditional sweeper. The resulting labour savings frees people up to do other work and get jobs done faster or reduces your need for staff.
• Increased Ease of Use: There is a real improvement experienced by the operator because there is not as much bending over involved. Each of the 2 trays hold 42 lbs of shot, it's easy to see when the tray is full and when it's full the handle is easy to grab and you just dump it into whatever you want. The sweepers are so easy to use that it's turns an undesirable job into one that no one minds doing. It's like using a power circular saw versus a handsaw.
• Reduced Long Term Cost: The Atmos is designed to last. And because of the quality of its design and construction and because of the availablity of replacement parts when needed you can keep your Atmos going for years resulting in lower long term costs of ownership compared to many cheaper magnetic sweepers. Parts are available for the Atmos on this website or from Bluestreak dealers.
• Increase Your company's adaptability / flexibility to economic cycles: When you're really busy the Atmos allows you to get the job done faster with the same amount of staff without hiring and when things slow down you won't have too many staff.
• Long maintenance free life. N42 rare earth magnets won't lose their strength over time and are permanently charged.
• 114 lb sweeper weight is easy to load into a truck.
• Completely seeled magnetic drum won't allow shot inside.
• Non-marking Thermoplastic rubber wheels with sealed bearings won't leave markes on floor surfaces and no dust or grit can get into the bearings.
• Converts to a tow behind by flipping the handle.

Recommended Applications:

• Shot Blasting Only

See how the Atmos is packaged for shipping

Add a Atmos Continuous Discharge
Magnetic Sweeper to your shopping cart

100 % Satisfaction Guaranteed!